[wow] Car 144 Red LED Centre High Mount Third Stop Brake Light Bar Signal Flowing Lamp [wow] tại Lotte Market

Giới thiệu [wow] Car 144 Red LED Centre High Mount Third Stop Brake Light Bar Signal Flowing Lamp [wow] tại Lotte Market

Product Description

This listing is for one set universal roofline LED third brake tail lights, it will fit most cars as a 3rd brake light.

A universal length LED lights as a 3rd brake light on the rear windshield, even your vehicle has an upper 3rd brake light already, you still can install this lights on your cars easily.

Unique lighting output, it will give your car a style and feel that is similar to the new Audi A7, BMW 6 Series Gran Coupe, Bentley Continental, and Tesla Model S

With double-sided tape, you can easily install the lights on the rear windshield, just make sure your window is clean and free from any smudges before installing.


This roofline LED 3rd brake light strip is designed to interior use only. Do not apply the LED third brake light outside of your car

This LED light is polar sensitive. If you have wired the LED brakelight kit and it does not light up, try flipping the connector.




Specifications:

Placement on Vehicle: Rear

To Fit: Brake Light

Led Number: 144LED


Waterproof Rate: IP67

Light length: 90CM


Compatibility instructions:


The length of your rear windshield is at least 1M

If your existing brake light is in the way and is not removable, you will need to make some adjustments in order to affix the LED brake striplight. If you are trying to install this on an SUV that does not have a sloped windshield, you may be able to create your own holding brackets so that you can mount it in your SUV.




Installation:

Step 1: Wipe down the surface so your LED 3rd brake light can properly adhere to the glass surface.?

Step 2: Measure the length of the upper rear windshield so you know where you can line up the roofline LED brake light.

Step 3: Peel off the double-sided tape film and carefully apply the LED third brake light onto the upper rear windshield location. Hold it for 30 seconds to one minute.


Step 4: After it fully adheres, draw the wires to the existing 3rd brake light harness or tap it to the left/right tail light to finish.

Package Included:1x LED Third Brake Tail Light Kit