W5100 Ethernet Shield Lan Cable For Arduino R3 tại Lotte Market

Giới thiệu W5100 Ethernet Shield Lan Cable For Arduino R3 tại Lotte Market

Ethernet Shield W5100

Hardwired TCP/IP embedded Ethernet controller that enables easier Internet connection for embedded systems.


Key Features
Hardwired TCP/IP protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
Un-attackable hardware network engine for preventing network attacks such as flooding, spoofing, injection
Host Interface : Direct/Indirect Bus & Serial Peripheral Interface (SPI MODE 0, 3)
4 Independent hardware socket
Internal 16Kbytes memory for TCP/IP packet processing
10BaseT / 100Base TX Ethernet PHY Embedded
Support Auto-Negotiation (Full & Half Duplex, 10 & 100 Based)
Support Auto-MDIX
3.3V Operation with 5V I/O signal tolerance
LED outputs (TX, RX, full/half duplex, Collision, link, speed)
80LQFP lead-free package (10x10mm)


The shield contains a number of informational LEDs:

PWR: indicates that the board and shield are powered
LINK: indicates the presence of a network link and flashes when the shield transmits or receives data
FULLD: indicates that the network connection is full duplex
100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)
RX: flashes when the shield receives data
TX: flashes when the shield sends data
COLL: flashes when network collisions are detected


Any Question can pm us


#w5100 #ethernetshield #arduinolan #Arduino #Shield