Vòng đèn LED RGB 5050 tích hợp cảm biến 37 trong 1 cho Arduino tại Lotte Market

Giới thiệu Vòng đèn LED RGB 5050 tích hợp cảm biến 37 trong 1 cho Arduino tại Lotte Market

set2: 37 x sensor kit + 1 x RGB LED Ring 24 Bit WS2812 5050 RGB LED with Integrated Driver
Intelligent reverse polarity protection, power supply reverse polarity will not damage the IC. IC control circuit and a power LED spot light utility.
Control circuit chip with RGB components in a package in 5050, to form a complete external control pixels.
Built-in signal shaping circuit, any one pixel after receiving the signal through the waveform shaping and then output to ensure line waveform distortion will not accumulate.
Built-in power-on reset and brown-out reset circuit.

Brand New
for Ready to be connected to Raspberry and Arduino
A great package for Arduino experiments or as a basis for a larger project
Package comes in a handy protective component box
8 analog Pin with power output and GND
Trichromatic color of each pixel can realize 256 highlighted, complete 16777216 colors of all true color display, the scanning frequency is not less than 400Hz / s.
Serial cascade interface, through a signal line to complete the receiving and decoding of data.
Transfer transmission distance between any two points in less than 5 meters without any additional circuitry.
When the refresh rate of 30 frames / sec, cascading number of not less than 1024 points.
Data transmission speeds of up to 800Kbps.
The color of the light highly consistent, cost-effective.
Specifications:
Chip: WS2812
LED Color: RGB
LED Type: 5050
Board Color: Black
Outer Diameter: 85mm
Inner Diameter: 71mm
For Arduino
Includes basic components and sensors
colour:Color as shown
Material:Metal +pc/plastic

Package Contents:
37 x sensor kit
1 x RGB LED Ring 24 Bit WS2812 5050 RGB LED with Integrated DriverOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.