Mô Đun Điều Khiển Động Cơ Kép 2.5a Pwm Cho Arduino L298N 2.5a tại Lotte Market

Giới thiệu Mô Đun Điều Khiển Động Cơ Kép 2.5a Pwm Cho Arduino L298N 2.5a tại Lotte Market

2.5A dual-channel motor drive module forward and reverse PWM speed regulation dual H-bridge stepper motor super L298N

Introduction:
2.5A power enhanced motor drive module, with high configuration version (including silicone wire, pin header, terminal) and standard version to choose from, power supply voltage 2V~10V, can drive two DC motors or 1 4-wire 2-phase at the same time The stepping motor can realize the functions of forward and reverse rotation and speed regulation, with thermal protection and automatic recovery.
Model: XY-2.5AD

Highlights:
1. It adopts imported original professional motor drive chip, built-in low conduction internal resistance MOS switch tube, very small heat generation, no heat sink, small size, and power saving. It is an ideal choice for your battery power supply.
2. Dual 2.5A*2, it is an enhanced version of 1.5A motor drive, with built-in overheating protection circuit, so you don’t have to worry about the motor being blocked and burned out, and it will automatically recover after the temperature drops.
3. Small size, light weight, 0 standby current, high configuration version and standard version to choose from.

parameter:
1. Dual H-bridge motor drive, which can drive two DC motors or one 4-wire two-phase stepping motor at the same time;
2. Module power supply voltage 2V-10V;
3. The signal terminal input voltage is 1.8-7V;
4. Single channel working current 2.5A, low standby current (less than 0.1uA);
5. Built-in anti-common-state conduction circuit, when the input terminal is suspended, the motor will not malfunction;
6. Built-in overheating protection circuit (TSD) with hysteresis effect, no need to worry about motor stall;
7. Product size: 31*32*5mm (length, width and height), small size, suitable for assembly and vehicle;
8. Mounting hole diameter: 2 mm.
9. Weight: standard 5g, high-end 11g

Precautions:
1. Reverse connection of the positive and negative poles of the power supply will definitely cause circuit damage.
2. The chip will be thermally protected when the output is short-circuited to the ground or the output terminal is short-circuited, and the motor is blocked. However, the chip will be burned when the voltage is close to or exceeds 10V and the peak current exceeds 2.5A.