DY-AP3015 2x30W Class D Bảng mạch khuếch đại kỹ thuật số âm thanh nổi công suất cao kép với chiết áp âm lượng có thể điều chỉnh DC 8-24V tại Lotte Market
Thương hiệu: | Xem thêm Amply & Mixer Thương hiệuMô tả ngắn về DY-AP3015 2x30W Class D Bảng mạch khuếch đại kỹ thuật số âm thanh nổi công suất cao kép với chiết áp âm lượng có thể điều chỉnh DC 8-24V tại Lotte Market
Product name: 30W stereo digital power amplifier module. Working voltage: DC: 8~24V. Number of channels: stereo (dual channel). 18W*2 @12V 4Ω. 15W*2 @16V 8Ω. 30W*2 @24V 8Ω (need to add heat sink). 4 ohms (8-12V power supply). Module protection mechanism:. Short circuit protection. Note: In order to improve the performance of the module, it is recommended that the power amplifier: Còn hàng
** Quét mã QR bằng Zalo để mua trên điện thoại
Giới thiệu DY-AP3015 2x30W Class D Bảng mạch khuếch đại kỹ thuật số âm thanh nổi công suất cao kép với chiết áp âm lượng có thể điều chỉnh DC 8-24V tại Lotte Market
Product name: 30W stereo digital power amplifier module
Product model: DY-AP3015
Working voltage: DC: 8~24V
Working mode: Class D (PWM modulation)
Number of channels: stereo (dual channel)
Output power (@1KHz)
18W*2 @12V 4Ω
10W*2 @12V 8Ω
15W*2 @16V 8Ω
20W*2 @20V 8Ω
30W*2 @24V 8Ω (need to add heat sink)
Adapter speaker (30W~150W)
4 ohms (8-12V power supply)
8 ohms (8-24V power supply)
Module protection mechanism:
Reverse power protection
Short circuit protection
Self-recovery overheat protection
Note: In order to improve the performance of the module, it is recommended that the power amplifier chip plus a heat sink be used in application scenarios that exceed 20W*2.
Precautions for use:
1. The recommended power supply voltage is DC 8~24V, if it exceeds 26V, the chip will burn, and if it is lower than 8V, there will be noise.
2. The power supply does not exceed 12V when connected to a 4Ω speaker, and does not exceed 24V when connected to an 8Ω speaker.
3. The power supply current is recommended to be above 2A.
4. The working power of the module exceeds 20W*2, need to add heat sink
5. Ensure that the input sound source signal is 0.5V~1.5V
6. The speaker wire should not be too long, and it should be suitable within 1 meter
7. Pay attention to electrostatic protection. Before touching the power amplifier board, you must first discharge the static electricity on your hand to avoid the static electricity from puncturing the power amplifier chip. The digital power amplifier is more sensitive to static electricity.
8. It is recommended to use the speaker rated power of 30W and above to avoid the speaker burning and heating