Đèn ngủ mini R2-D2 họa tiết hoạt hình sáng tạo tại Lotte Market

Giới thiệu Đèn ngủ mini R2-D2 họa tiết hoạt hình sáng tạo tại Lotte Market

Describe:

Light color: Mini R2-D2

Light source power: less than 5W (W)

Voltage: ≤36V (V)

Shade material: ABS

Dimensions: 166*40*157 (mm)

Product weight: 165g

Switch type: toggle type

Style: cartoon

Average service life: 100000 (h)

Power supply mode: battery

Packing list: cracked sticker*1 manual*2 expansion screw*2 installation screw (without battery)

Important installation instructions:
This product is for indoor use only
Do not put it in water or use it near water.
Set only on objects with a solid surface structure.
Do not hang near gas or electric heaters, sources of goods, candles or other heat sources.

Battery safety instructions:
The installation and replacement of the battery should be operated by an adult,
Please turn off the lights during the day to extend the battery life.
Please place the battery safely.

Sticker description:
Please read all instructions before using stickers and installing night lights.
Please put the sticker on a flat wall, and make sure that it is free of dust and grit and dry. You can use the sticker at least 2 weeks after the newly painted wall. Open the sticker and smooth the crease:
1. Put the sticker on the desired position, and stick two pieces of tape on the top edge of the sticker (drawable tape or similar, mark the top of the tape and sticker with arrows to locate the position of the sticker).
2. Carefully remove the back of the sticker.
3. Align the arrows and stick the top of the sticker (1-2 feet from the top) on the wall, but hold the bottom away from the wall.
4. Attach a bank card or other flat surface object to the sticker. The bottom of the sticker must be far away from the wall. Slowly press down on the back of the sticker to remove all bubbles.
5. Slowly tear off the sticker from the wall, making sure that the small edge of the sticker sticks to the wall. If the sticker peels off with the surface paper, just press it on the wall again, and at the same time press firmly with the bank card until the sticker sticks to the wall.
6. Drill holes at the place marked X and install the expansion screws provided. Then screw three-quarters of the screws into the wall, and then place the light on the screws.