Cảm Biến Nhiệt Độ Pt100 Cho Mạng Nhện V1.1 tại Lotte Market

Giới thiệu Cảm Biến Nhiệt Độ Pt100 Cho Mạng Nhện V1.1 tại Lotte Market

Description:
Made of quality material, easy to install. The main chip adopts MAX31865.
Only a temperature detection conversion module and can not directly measure temperature.
Support two-wire three-wire Pt100 temperature measurement.
The item is professional 3pin temperature header Pt100 stick.
Fits for voron 2.4 spider motherboard 3D printer.
Specification:
Material: ABS plastic
Size: 15x20mm/0.6x0.8inch

Under [extruder] add these lines:
sensor_type: MAX31865
sensor_pin: PD11 # I pulg into Spider E4-MOT socket, `cs` pin is the sensor pin
spi_speed: 4000000
spi_software_sclk_pin: PE12
spi_software_mosi_pin: PE14
spi_software_miso_pin: PE13
rtd_nominal_r: 100
rtd_reference_r: 430
rtd_num_of_wires: 2
If you are in EU or any 50 Hz country add this line:rtd_use_50Hz_filter: True
Save your changes by typing CTRL+X, Y, [ENTER]. Send FIRMWARE_RESTART from the console and test! It should work.
Run PID tuning. PT100 readings will be different from your previous thermistor. For the best thermal accuracy, follow this to PID tune:
1. Heat your bed to 100C.
2. Move your hothend to the center and 5-10 mm above bed
3. Set fans to 25%: ”M106 S64”
4. Run: ”PID_CALIBRATE HEATER=extruder TARGET=245”
5. This will run for a few minutes. When finished, save with: ”SAVE_CONFIG”
Package Includes:
1 Piece Temperature Sensor
Note:
Please allow slightly 0-1cm difference due to manual measurement.
Thanks for your understanding and attention. Wish you a pleasant shopping experience!