Bộ điều khiển từ xa ESC cho ván trượt điện kèm dây đeo tại Lotte Market

Giới thiệu Bộ điều khiển từ xa ESC cho ván trượt điện kèm dây đeo tại Lotte Market

Description:
2CH Electric Skateboard Remote Control and Receiver
Universal remote control with receiver for electric skateboard
Compact, comfortable holding and easy to operate
Built-in battery, rechargeable
Designed with wrist strap, safe and easy to carry
Specification:
Frequency: 2.4G
Voltage: 3.7V
Battery: Built-in lithium battery
Capacity: 400MAH
Control: PWM
Output width: 1-1.5-2 milliseconds
Reset: automatically return to center
Charging method: wired charging
Charging port: Mico-USB
Charging voltage: 5V
Charging current: 500MA
Charging time: 2H
Overcharge protection
Remote control distance: 10M
Number of channels: 2
Receiver:
Frequency: 2.4G
Use voltage: 5V
ESC power supply
External power supply interface
Frequency line
Out of control protection
Number of channels: 2
How to bind the transmitter to the receiver?
1).Check and make sure all the wires are mounted,and the remote is CLOSED,insert the bind plug into CH3(Bind) on the receiver;
2).Switch on the ESC,you can see the receiver red light flash;
3).Press and hold on the bind button on the remote and then turn the remote on;
4).You should notice the transimitter go from flashing red to solid red,and also the solid red of the receiver;
5).Once you see a solid red light, you now know the two are binded together,and please pull the bind plug out (this is important,so the remote can record the throttle mid to realize the fail safe)
6).Then you can test it again by turning off the controller and it should flash.if you turn the power on Transmitter back on it should go back to solid red.Before running,it's better to test the fail safe fuction by closing the remote,if the motor didn't move,so the fail safe fuction is in good
Package Includes:
1 Piece Remote Control
1 Piece Receiver