Bảng mạch điều khiển động cơ bước L298N cho Arduino tại Lotte Market

Giới thiệu Bảng mạch điều khiển động cơ bước L298N cho Arduino tại Lotte Market

1PCS New Dual H Bridge DC Stepper Motor Drive Controller Board Module L298N for Ar-duino Free Shipping TK0450

Description:
The L298N driver module, using ST L298N chip can directly drive two 3-30V DC motor, and provides a 5V output interface, you can chip circuitry to 5V power supply, support 3.3VMCU control, you can easily control the DC motor speed and direction, you can also control the 2-phase stepper motor, smart car essential.

Parameters:
1 Driver chip: L298N dual H-bridge driver chip
2 Terminal driver part of the supply area VMS: +5V ~ +35V
3 Drive part of the peak current Io: 2A / Bridge
4 Logical part of the terminal power supply range Vss :4.5-5 .5V
5 Logical part of the operating current range: 0 ~ 36mA
6 The control signal input voltage range: 4.5-5.5V low 0V high
7 Maximum power consumption: 20W
8 Storage temperature: -25 ~ +130
9 Driver Board Size: 55mm * 60mm * 30mm
10 Driver board Weight: 33g
11 Other features: control direction indicator, power indicator, current detection, logical part of the plate to take power interface.

Package:
1pcs x L298N Module

Notes:
1. When you are driving voltage (above logo for the 12 v input, can actually accept input range is 7 to 12 v) for 7 v to 12 v, can make to onboard power supply 5 v logic, when using the onboard after 5 v power supply, interface of + 5 v
The power supply does not input voltage, but can yield 5V voltage for external use.
​2. When the driving voltage is higher than 12V, it is less than or equal to 24V
(the chip manual proposes to support 35V, but according to the book
When the maximum voltage is applied to the maximum voltage of 298 conservative applications to 24V, for example, the motor with a rated voltage of 18V shall be driven.
You must first remove the board 5V output to enable the jumper cap. Then 5V is accessed outside the 5V output port
The 5V enables the power to be a control signal with a level of 5V. When the signal input is valid, and when the power supply is normal in the motor drive module, the motor drive module outputs the current. Otherwise, even if the power supply is normal, there is no current on the motor.
Voltage to L298N internal logic circuit power supply. (this is a high-pressure, unconventional app!)