Bảng Mạch Bảo Vệ Pin Lithium 14s 48v 60a-100a tại Lotte Market

Giới thiệu Bảng Mạch Bảo Vệ Pin Lithium 14s 48v 60a-100a tại Lotte Market

Applicable battery: ternary battery Nominal: 3.6V/3.7V, protection parameter 2.8V-4.25V
Motor power: within 1440W/within 1800W/2400W within/2800W
Controller current limit: within 45A/ within 65A/ within 85A/ within 100A

Built-in temperature control with equalization light
TVS upgrade, reduce MOS tube breakdown, safety protection and absorption of high voltage
Overcharge protection/overcurrent protection/overdischarge protection
Short circuit protection/balance protection/temperature control protection
Static protection / dust protection / moisture protection

Discharge current: 60A/80A/100A
Discharge overcurrent protection value: 2-4 times of continuous current
Main circuit conduction internal resistance: <20 mΩ
Charging current [same port]: 40A/60A/80A/100A
Charging voltage: ternary battery string number x4.2V

Overcharge protection:
Detection voltage: ternary 4.25 ± 0.03V
Detection delay: 1000 ms
Release voltage: ternary 4.19 ± 0.05V

Over discharge voltage protection:
Detection voltage: ternary 2.8 ± 0.1V
Detection delay: 100mS
Release voltage: three yuan 2.9 soil 0.1V

Balance voltage:
Detection voltage: ternary ≥ 4.18V
Release voltage: ternary <4.18V
Balance current: 20-30 mA

Over discharge current protection:
Detection delay: 100 ms
Release condition: disconnect load/charge activation
Temperature control protection:
Discharge over temperature protection: 75 ± 5°C
Discharge high temperature release temperature: 53°C
Operating temperature:
Temperature range: -20°C/+80°C

1. First connect the B- line to the battery negative terminal (the B- line needs to be welded with a short wire first), and then connect the flat cable (before connecting the flat cable, first unplug the flat cable from the board)
2. Start wiring from the BCO, connect the BCO to the total negative electrode of the battery (name this string ①), the cable BC1 next to the BCO connects to the positive electrode of the number ① battery, and the third cable BC2 connects to the positive electrode of the battery number ②. The four flat wires BC3 are connected to the number ③The positive electrode of the battery...and so on.
3. After connecting the cables, measure the voltage between each two adjacent cables from the header. The voltage of the polymer battery should be less than 4V, and the voltage of the iron-lithium battery should be less than 3.5V. Insert the cable after checking.
4. Connect the negative pole of the charger and the negative pole of the load to C-. B negative wires and C negative wires need to be welded with thick wires. The wiring method has nothing to do with the color, only the correct order is required.
5. Then measure whether the total battery voltage is equal to the output voltage of the protection board, and the protection board works normally if it is equal.