Aaron1 Thiết Bị Kiểm Tra Dung Lượng Pin Lithium Js-C33 10-100v Màn Hình Lcd tại Lotte Market
Thương hiệu: | Xem thêm Dụng cụ & thiết bị lớn Thương hiệuMô tả ngắn về Aaron1 Thiết Bị Kiểm Tra Dung Lượng Pin Lithium Js-C33 10-100v Màn Hình Lcd tại Lotte Market
Package include: 1pcs Battery Capacity Indicator Voltage Monitor. Working temperature:-10~55. Product size:61. Sleep power:6-12uA (20V). Voltage accuracy:±0. long time switch, can display the battery voltage, can be used in a variety of light conditions. External NTC temperature sensor, please put the sensor to measure the temperature of the parts, do not. Red line to the positive terminal, black line toGiới thiệu Aaron1 Thiết Bị Kiểm Tra Dung Lượng Pin Lithium Js-C33 10-100v Màn Hình Lcd tại Lotte Market
Package include: 1pcs Battery Capacity Indicator Voltage Monitor
Installation size:58.5mm*28.5mm
Working temperature:-10~55
Display size:36mm*19.5mm
Product size:61.5mm*33.5mm*13.5mm
Working voltage:10V-100V
Sleep power:6-12uA (20V)
Power waste:5-6mA (LED ON)
Voltage accuracy:±0.1(Typical),±0.5(Max)
This product is a universal instrument, the color LCD screen, with low power consumption,
long time switch, can display the battery voltage, can be used in a variety of light conditions.
Instruction:
1. PH2.0 terminal products supporting the use of wire, connected to the circuit board face should plug back.
2. External NTC temperature sensor, please put the sensor to measure the temperature of the parts, do not
squeeze the sensor( selective assembly).
3. Red line to the positive terminal, black line to the negative terminal.
4. After the instrument is powered on , which shows the percentage of the battery power, the voltage value,
and the symbols of the analog battery.
5. Press the button to turn off the instrument. In close mode, you can wake up the instrument by pressing
any button.
6. Click the button , you can switch the voltage value and temperature value display.
7. The battery symbols on the display interface, from the right to the left, are 7 display boxes representing the
pool power from low to high.
8. The voltage on the display interface is measured in real time, and the voltage value is displayed on
10-100V.
9. The percentage on the display interface is the percentage of the remaining battery power
10. When the battery is connected to the charger or the discharge of the high current load, the display
parameters will fluctuate
11. The red light flashes the alarm when the battery is low
12. If the battery specification is special, you can enter the set mode 3-- and reset the upper and lower limits of
the measured battery voltage.
Notice:
The default setting is suitable for use in 12V lead acid batteries.
If you need to set up other types of batteries, or go into settings mode and delay time switch settings, please contact us, we will send electronic English instructions to you.