1-Channel 12V Optocoler cho Arduino mới tại Lotte Market

Giới thiệu 1-Channel 12V Optocoler cho Arduino mới tại Lotte Market

1 pcs 12V 1 channel relay ule & 75Pcs Type PC Crown Gear
1 channel relay ule, with photoelectric isolation
High or Low level changeable(by a jumper setting trigger)
The ule uses quality relay
With power and relay action indicator

12V 1 channel relay ule:
Operating voltage: 12V
Material: CCL
Color: red
Maximum load: AC 250V / 10A, DC 30V / 10A
Size:44 x 24 x 17mm
Pins:
DC+: Positive power supply (VCC)(12V)
DC-: Negative power supply (GND)
IN: The control end, the driving current should be more than 4mA
COM: The control of loop of earth wire
GND: Ground
Notice:
High Level e: the jumper is set between com and gnd (original).
Low Level e: take down the jumper, connect VCC to VCC, GND to Control Terminal, IN to 5V, COM to GND.
gear:
Material:PC
Type:spindle gear,crown gear,sigle gear,double gear,worn gear,bevel gear,belt pulley,belt,connecting rack,axle sleeve,tee collar
Color: picture color

Package Contents:
1 x 12V 1 channel relay ule
19 x Double Reduction Gear(each one)
12 x Single Reduction Gear(each one)
11 x Crow Gear(each one)
2 x Worm Gear(each one)
9 x Spindle Gear(each one)
7 x Belt Pulley(each one)
6 x Axle Sleeve(each one)
5 x Belt(each one)
2 x Connectiong Rack(each one)
1 x Tee CollarOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.